Teledyne 804A User Manual page 60

804 Series Video Test Generator – User Guide
4. Touch select the Mode
on. You can either select All Ports or only a single port which you specify using the Tx Port button
5. Touch select the Tx Port x
Touch select Auto-Restart to restart HDCP 2.2 authentication in the event that it fails.
6. Touch select Enable from the HDCP Output Test menu shown above.
The Pass/Fail results are presented on the screen as shown below.
7. Repeat for each HDMI port you wish to test by selecting the lower button (Tx Port x).
Page 60
activation button to determine which ports you want to run the authentication
until the desired port is shown.
Revision B3