Instructions For Use; Powering Up The 804/804A/804B; Powering Down And Uninstalling The 804/804A/804B - Teledyne 804A User Manual

804 Series Video Test Generator – User Guide
5

Instructions for Use

This section provides the Instructions for Use for the 804/804A/804B describes power up and general operation.
Note: If the 804/804A/804B is used in a manner not specified in the guide, the protection provided by the equipment may be
impaired.
5.1

Powering up the 804/804A/804B

The procedures below describe how to power up the 804/804A/804B.
1. Connect the power cable provided with the 804/804A/804B to the connector on the back. Refer to the illustration below.
Note: Any replacement power cord that you use should be certified to the requirements in IEC 60799.
2. Apply power on the power connector switch on the back near the power connector.
3. Power up the 804/804A/804B using the rocker switch on the front panel.
5.2

Powering down and uninstalling the 804/804A/804B

In the event you have to remove the 804/804A/804B from its normal operating location, use the following instructions:
1. Power down the 804/804A/804B using the rocker power switch on the front of the unit.
Page 13 Revision B3