Default Display - Siemens SIPROTEC 4 7VK61 Manual

Default Settings and Protocol-dependent Functions
D.5 Default Display
D.5

Default Display

4-line Display
The following selection is available as start page which may be configured. Parameter 640 Start image DD
allows to select which of the available default displays will be displayed in normal mode.
[vk61-alle-grundbilder-261102-kn, 1, en_GB]
Figure D-1
Spontaneous Fault Indication of the 4-Line Display
The spontaneous annunciations on devices with 4-line display serve to display the most important data about
a fault. They appear automatically in the display after pick-up of the device, in the sequence shown below.
Relay PICKUP:
PU Time
TRIP Time
282
Default displays
A message indicating the protective function that
picked up first
Elapsed time from pick-up until drop-off
Elapsed time from pick-up until the first trip command
of a protection function
C53000-G1176-C159-5, Edition 05.2018
SIPROTEC 4, 7VK61, Manual