Mounting and Commissioning
3.1 Mounting and Connections
Binary inputs
BI14
BI15
BI16
BI17
BI18
BI19
BI20
1)
Factory settings for devices with power supply voltages of DC 24 to 125 V
2)
Factory settings for devices with power supply voltages of DC 110 to 250 V and AC 115/230 V
3)
Only use for control voltages DC 220 to 250 V and AC 230 V
Jumpers X71, X72 and X73 on the input/output board C-I/O-4 are used for setting the bus address and must
not be changed. The following Table lists the jumper presettings.
Table 3-9
Jumper
X71
X72
X73
Input/output module C-I/O-2 up to release7VK61 .../DD
There are two different releases of the input output module C-I/O-2. For devices up to release 7VK61.../DD the
layout of the printed circuit board is shown in
190
Jumper
X29
X30
X31
X32
X33
X34
X35
Jumper setting of the module addresses of the input/output board C-I/O-4
Threshold 19 V
1)
Threshold 88 V
1-2
2-3
1-2
2-3
1-2
2-3
1-2
2-3
1-2
2-3
1-2
2-3
1-2
2-3
Mounting location
1-2 (H)
2-3 (L)
1-2 (H)
Figure
3-8, for devices of release 7VK61.../FF in
4)
Threshold 176 V
3-4
3-4
3-4
3-4
3-4
3-4
3-4
Figure
3-8.
SIPROTEC 4, 7VK61, Manual
C53000-G1176-C159-5, Edition 05.2018
5)