Set Packet-Service Command Hierarchy; Provisioning Ptp - Symmetricom TimeProvider 5000 User Manual

Provisioning PTP

By default, the TP5000 is provisioned as a PTP grandmaster enabled for PTP
unicast dynamic negotiation, except for versions that are purchased as dedicated
NTP servers. The TP5000 also supports up to 10 unicast static clients per port. The
"set ptp" command is used to provision PTP parameters common to multicast,
unicast (dynamic and static), and multicast-hybrid configurations. See
Figure 4-9 and
4-3 for descriptions of the Common parameters and
ranges. including those commands for setting the addressing mode, management
addressing mode and two-step clock mode.
Packet Service Modes
Each Ethernet port on the TP5000 IOC module can be configured as either a PTP
grandmaster or as an NTP server, with PTP grandmaster as the default. The
exception is for versions that are purchased as dedicated NTP servers. See for
Figure 4-7.

Set Packet-Service Command Hierarchy

Use the following procedure to configure Port 1 of IOC1 as a PTP grandmaster:
1. Login at the Admin.
2. Type
set packet-service ioc1-1 ptp-gm
Addressing Modes
The TP5000 Grandmaster can be configured to run in one of three addressing
modes:
Unicast

Multicast

Multicast-Hybrid

098-00028-003 Revision A – June, 2011
Figure 4-10 for the hierarchy of the "set ptp" commands.
Chapter 4 Provisioning
Figure
Table B-21 for defaults and
and press Enter.
TimeProvider 5000 User's Guide 249
Provisioning PTP
4-8,
SeeTable