Symmetricom TimeProvider 5000 User Manual page 119

show input-config
This command displays the input port's state, priority, framing type, CRC, SSM
state, SSM Bit, user-assigned SSM PQL value and whether the configuration
settings for the port are used. The settings will not be used if the port is configured
as an output..
Note: Setting the Time of Day source to GPS with the
tod-source
Disable.
Command Syntax:
show input-config
Example:
tp5000> show input-config
Response:
------------------------------------------------------------------------------
|Port ID| State |Prio|Frame Type |CRC St |SSM St |SSM Bit|SSM Val|Config Used|
|-------|-------|----|-----------|-------|-------|-------|-------|-----------|
| port1 |disable| 1
|.......|.......|....|...........|.......|.......|.......|.......|...........|
| port2 |disable| 2
|.......|.......|....|...........|.......|.......|.......|.......|...........|
Note: See 'show io-status' for current port status and
direction.
Level : User, Config, and Admin
set input
Use this command to provision the System's Input Port(s) for the following:
Priority

State

Framing Type

CRC state for E1 signals

SSM state

SSM Bit position for E1 signals

SSM PQL Value (this value is used if SSM is disabled)

098-00028-003 Revision A – June, 2011
command will also set the input reference port state to
|cas |disable|disable| 8
|freq2048khz|disable|disable| 8
Chapter 3
TimeProvider 5000 CLI Command Set
set
| 3 | no
| 3 | yes
TimeProvider 5000 User's Guide 119
|
|