Expansion Port Status - Symmetricom TimeProvider 5000 User Manual

Port
----------------------------------------------------------
in1:
in2:
out1:
out2:
Response 3b:
Port
--------------------------------------------------------
in1:
in2:
out1:
out2:
Level : DTI input port status of "active" means the port is selected as reference
Level : User, Config and Admin
Table 3-1. Expansion Port Status
Status Input/Output
Active Input and Output
Standby
Redundant
Disqualified
Disconnected
098-00028-003 Revision A – June, 2011
dti link
up
disabled
up
down
dti link
down
up
up
down
An input is qualified and also selected.
An output that is determined to be "active", "standby", or
"redundant" by the downstream input.
Input only An input is qualified but not selected.
If the active input is disqualified, the standby input will be
selected after several seconds.
Input only An input that could have been qualified, except that a
timing loop condition existed.
If the other input is disqualified, the redundant input will
be selected after a delay to allow stabilization of the
system.
Input only An input that is disqualified
Output only A DTI output that is not connected to a DTI input
TimeProvider 5000 CLI Command Set
dti status
active
standby
active
disconnected
dti status eth link
disqualified
disqualified
active
disconnected
Description
TimeProvider 5000 User's Guide
Chapter 3
eth link
up
down
up
up
down
up
up
up
99