sync-limit = -7
delay-limit = -7
domain-value = 0
dscp-value = 0
dscp-state = Disable
priority-1 value = 128
priority-2 value = 128
Multicast announce-timeout = 3
Multicast client-timeout = 300
Multicast announce-int = 1 (2 seconds)
Multicast sync-int = -6 (0.015625 second)
Multicast delay-int = -7 (
Multicast VLAN ID = 0
Unicast Dynamic Negotiation = Enable
Unicast Dynamic Lease Duration = 1000 seconds
Unicast Static State = Disable
Unicast Static IP Address = 0.0.0.0
Unicast Static VLAN = 0
Unicast Static Clock-ID = MAC-based value,
Unicast Static announce-int value = 1 (2 seconds)
Unicast Static sync-int value = -3 (0.125 seconds)
Unicast Static delay-int value = -3 (0.125 seconds)
Example 1
To set the addressing mode for port 1 of IOC1 to multicast-hybrid:
tp5000> set ptp addr-mode ioc1-1 multicast-hybrid
Example 2
To set the management addressing mode for port 1 of IOC1 to unicast:
tp5000> set ptp mgmt-addr-mode ioc1-1 unicast
Note: Management addressing mode controls whether PTP
management messages use Multicast or Unicast. This is independent
of the set ptp addr-mode command. For example, management
addressing can be set for Multicast while PTP synchronization is
using Unicast. For multicast management, the client must be in the
TP5000's client list.
Example 3
To set the maximum number of clients to "100" for port 1 of IOC1:
tp5000> set ptp max-client ioc1-1 100
Example 4
098-00028-003 Revision A – June, 2011
(0.0078125 seconds)
(0.0078125 seconds)
(i.e. FF:FE inserted in the middle of MAC address)
Common Attributes:
Common Attributes:
Common Attributes:
Common Attributes:
TimeProvider 5000 CLI Command Set
second)
0.0078125
TimeProvider 5000 User's Guide 181
Chapter 3