Symmetricom TimeProvider 5000 User Manual page 179

set ptp unicast static announce-int {ioc1-1 | ioc1-2}
index [1 - 10] <announce-int-value
– The interval is 2
To provision the interval between delay response messages for PTP Unicast

static:
set ptp unicast static delay-int {ioc1-1 | ioc1-2}
index [1 - 10] <delay-int-value>
– The interval is 2
Expansion Shelf Attributes (Multicast):
To provision the state of the PTP outputs for the PTP/Synce expansion shelf:

set ptp state exp[0-9] [port[1-16] | all] [enable | disable]
To provision the PTP timescale for the PTP/Synce expansion shelf:

set ptp timescale exp[0-9] [auto | arb | ptp]
To provision the PTP clock to two-step or one-step mode for the PTP/Synce

expansion shelf:
set ptp two-step exp[0-9] [enable | disable]
To provision the PTP alternate-master for the PTP/Synce expansion shelf:

set ptp alternate-master exp[0-9] [enable | disable]
To provision the Priority 1 value for the PTP/Synce expansion shelf:

set ptp priority1 exp[0-9] <priority1-value>
To provision the Priority 2 value for the PTP/Synce expansion shelf:

set ptp priority2 exp[0-9] <priority2-value>
To provision domain for the PTP/Synce expansion shelf:

set ptp domain exp[0-9] <domain-value>
To provision the dither for the for the PTP/Synce expansion shelf:

set ptp dither exp[0-9] [enable | disable]
To provision the clock ID for the PTP/Synce expansion shelf:

set ptp clockid exp[0-9] <clockid-value>
098-00028-003 Revision A – June, 2011
z
seconds, where z= <announce-int-value>.
z
seconds, where z= <delay-limit-value>.
TimeProvider 5000 CLI Command Set
>
TimeProvider 5000 User's Guide 179
Chapter 3