Disabling Specific Alarms - Symmetricom TimeProvider 5000 User Manual

Disabling Specific Alarms

The Set Alarm-Config command allows you to enable or disable specified alarms.
Example
To disable the GNSS/GPS antenna open-circuit alarm (alarm #13), enter the
following:
1. Login at the Admin or Config-user level (see
2. Type
set alarm-config state alarm 13 disable
Showing Current Alarm Settings
The Show Alarm-Config command displays the set and clear alarm thresholds for
every alarm type.
Example
To display the configuration for all alarm types, enter the following:
1. Type
show alarm-config
Showing Current Alarms
The Show Alarm command displays all current alarms.
Example
To display a list of all current alarms enter the following:
1. Type
show alarm
Displaying Alarm and Unit Status
The Show Status command displays the system status information as follows:
Assigned System Name

Uptime for the IMC card and IOC card

System date and time

Number of standing system alarms

Active IOC card

Standby IOC card

Currently selected reference mode

098-00028-003 Revision A – June, 2011
and press Enter.
and press Enter.
Chapter 4 Provisioning
Provisioning Alarms
Logging In, on page 235).
and press Enter.
TimeProvider 5000 User's Guide 303