Symmetricom TimeProvider 5000 User Manual page 107

set gnss mask <mask-value>
To set the GNSS cable-delay value

set gnss cable-delay <delay-value>
Range: Height:
Mask: 5 to 45 degrees
Cable Delay: 0 to 65485 nanoseconds
Priority: 1 to 16, where 1 is highest priority and 16 is lowest
Default: Mask: 10 degrees
Cable Delay: 0 nanoseconds
Example 1:
To set GNSS to auto mode 

tp5000>set gnss mode auto
Example 2:
To manually set the GNSS to manual mode, with a system position of latitude of
N37:22:45.123, longitude of W121:55:36.123, and a height 17.5 meters
tp5000>set gnss mode manual latitude N37:22:45.123 longitude
W121:55:36.123 height 17.5
Example 3:
To enable GNSS on the GNSS port 

tp5000>set gnss state enable
Example 4:
To set GNSS priority on the GNSS port to a value of 3 

tp5000>set gnss priority 3
Example 5:
To set the GNSS mask to a value of 25 degrees 
tp5000>set gnss mask 25
Example 6:
To set the GNSS cable delay to a value of 220 nanoseconds 
098-00028-003 Revision A – June, 2011
-999.9 to 40000.0 meters
Chapter 3
TimeProvider 5000 CLI Command Set
TimeProvider 5000 User's Guide 107