Symmetricom TimeProvider 5000 User Manual page 227

set vlan
This command is used to provision the VLAN mode for an IOC port , as well as to
provision the state for a defined VLAN configuration.
Use this command to add a new VLAN configuration to an IOC port and provision its
Host, Mask, and Gateway IP addresses. This command also can be used to modify
or delete an existing VLAN configuration. Each VLAN must be configured with its
own IP address on a separate subnet.
Note: If the Ethernet interface is not to be part of a VLAN, use the
command
Command Syntax:
To provision VLAN mode for the specified port or expansion shelf:

set vlan-mode {ioc1-1 | ioc1-2 | exp[0-9]} {enable |
disable}
To add a VLAN ID, IP address, netmask, and gateway for the specified port or

expansion shelf:
set vlan-config add {ioc1-1 | ioc1-2} index {1 thru 16}
vlan-id <vlan-id> priority <priority> address <ip-address>
netmask <mask> gateway <gateway>
Note: If a gateway router is not required, then set the gateway value
to the special value of 0.0.0.0
Note: When using VLANs, the network administrator should configure
the Ethernet switches and/or router to handle the VLANs.
To modify the IP address, netmask, or gateway for an existing VLAN

configuration on the specified port:
set vlan-config modify ioc1-[y] index {1 thru 16} address
<ip-address> netmask <mask> gateway <gateway>
To delete the VLAN configuration for the specified index on the specified port:

set vlan-config delete {ioc1-1 | ioc1-2} index {1 thru 16}
To provision the state of the VLAN for the specified index on the specified port:

set vlan-config state {ioc1-1 | ioc1-2} index {1 thru 16}
{enable | disable}
To provision the VLAN for the specified port and expansion shelf:

098-00028-003 Revision A – June, 2011
set ip
, on page 133 to provision the IP addresses instead.
Chapter 3
TimeProvider 5000 CLI Command Set
TimeProvider 5000 User's Guide 227