Symmetricom TimeProvider 5000 User Manual page 176

Chapter 3
TimeProvider 5000 CLI Command Set
set ptp ttl {ioc1-1 | ioc1-2} <TTL-value>
To provision the PTP maximum number of clients:

set ptp max-client {ioc1-1 | ioc1-2} <max-client value>
To provision the announce limit, the minimum interval (maximum rate) between

PTP announce messages:
set ptp announce-limit {ioc1-1 | ioc1-2} <announce-limit
value>
– The interval is 2
To provision the synchronization limit, the minimum interval (maximum rate)

between PTP synchronization messages:
set ptp sync-limit {ioc1-1 | ioc1-2} <sync-limit value>
– The interval is 2
To provision the delay limit, the minimum interval (maximum rate) between PTP

delay response messages:
set ptp delay-limit {ioc1-1 | ioc1-2} <delay-limit value>
– The interval is 2
To provision the PTP priority-1:

set ptp priority-1 {ioc1-1 | ioc1-2 | exp[0-9]} <priority-1
value>
To provision the PTP priority-2:

set ptp priority-2 {ioc1-1 | ioc1-2 | exp[0-9]} <priority-2
value>
To provision the PTP domain:

set ptp domain {ioc1-1 | ioc1-2 | exp[0-9]} <domain-value>
To provision the PTP Diffserv Code Point value:

set ptp dscp ioc1-[y] <dscp-value>
To provision the PTP Diffserv Code Point state:

set ptp dscp-state ioc1-[y] {enable | disable}
To provision the PTP dither:

set ptp dither {ioc1-1 | ioc1-2 | exp[0-9]} {enable |
disable}
To provision the PTP master Clock ID:

set ptp clockid {ioc1-1 | ioc1-2 | exp[0-9]} <clockid>
176 TimeProvider 5000 User's Guide
z
seconds, where z= <announce-limit-value>.
z
seconds, where z= <sync-limit-value>.
z
seconds, where z= <delay-limit-value>.
098-00028-003 Revision A – June, 2011