Symmetricom TimeProvider 5000 User Manual page 260

Chapter 4 Provisioning
Provisioning PTP
Table 4-4. PTP
Parameter
client-timeout
announce-timeout
vlanid
announce-int
sync-int
delay-int
260 TimeProvider 5000 User's Guide

Multicast Addressing Mode Parameter Descriptions
Sets the client timeout value. If no delay request messages have
been received from a client before the specified client timeout
value, the Grandmaster removes that client from the client list.
Applies to Multicast and Multicast-Hybrid address modes.
Default = 1000 seconds
Sets the announce timeout value for Multicast address mode. This
should be set to a consistent value in the PTP domain.
Default = 3
Sets the VLAN ID for the Grandmaster in Multicast address mode.
A VLAN ID of 0 is used to specify that no VLAN is being used. Only
one VLAN will be supported in Multicast and Multicast-hybrid
address modes.
Default = 0
Sets the announce interval for the TP5000 Grandmaster, how often
to send announce messages to clients on the specified port.
Applies to Multicast and Multicast-Hybrid address modes.
The interval is 2
Default = 1 (2 seconds)
Sets the synchronization interval for the TP5000 Grandmaster, how
often to send synchronization messages to clients on the specified
port.
Applies to Multicast and Multicast-Hybrid address modes.
The interval is 2
Default = 6 (0.015625 seconds) [Rate =64 per second]
Sets the delay interval for the TP5000 Grandmaster, how often to
send delay response messages to clients on the specified port.
Applies to Multicast and Multicast-Hybrid address modes.
The interval is 2
Default = 7 (0.0078125 seconds) [Rate =128 per second]
Description
z
seconds, where z= <announce-int-value>.
z
seconds, where z= <sync-int-value>.
z
seconds, where z= <delay-int-value>.
098-00028-003 Revision A – June, 2011