Symmetricom TimeProvider 5000 User Manual page 154

Chapter 3
TimeProvider 5000 CLI Command Set
Clock State
Normal
Bridging
Holdover
Command Syntax:
To provision the state for the specified output port:

set output state {port1|port2|port3|port4} {enable|disable}
To provision the output frame type:

set output frametype {port1|port2|port3|port4}
Note: The default output frame type is freq2048khz.
Note:
frame types. This setting is not stored in non-volatile memory.
To provision the CRC output:

set output crc {port1|port2|port3|port4} {enable|disable}
To provision the SSM output:

set output ssm {port1|port2|port3|port4} {enable|disable}
To provision the output ssm-bit:

set output ssm-bit {port1|port2|port3|port4} [4 thru 8]
To provision the output behavior during the warm-up state:

set output warm-up {port1|port2|port3|port4}
{on|squelch|ais}
To provision the output behavior during the free-run state:

set output free-run {port1|port2|port3|port4}
{on|squelch|ais}
To provision the output behavior during the holdover state:

154 TimeProvider 5000 User's Guide
Output SSM
PQL of reference
or PRS for GPS mode
Last PQL of reference
PQL of reference
{ccs|cas|freq2048khz|d4|esf|freq1544khz}
The T1 isolated pulse mode has precedence over other
098-00028-003 Revision A – June, 2011