Symmetricom TimeProvider 5000 User Manual page 141

Remarks :
Level : User, Config, and Admin
set license
Use this command to enter the 40-character license key for new features or options,
and to delete features or options.
Licensing is used with TP5000 versions 1.2 and later. New features and options are
activated with a 40-character key. If the user has a 6-character key, the
command is used to enter the key. If the user has a 40-character key, the "set
license" command is used to enter the key. The license is associated with the serial
number of the IMC card.
Command Syntax:
To enter a license key for new features or options:

set license add
The TP 5000 will prompt for the license key.
To remove the current feature license:

set license delete feature
Note: When the current feature license is deleted using the
license delete feature
be restored. This is to ensure that the system configuration matches
the system functionality.
Restoring default configuration may take a while. If a command is
entered too soon after deleting the current license feature, before the
default configuration has been fully restored, the command will fail. If
this happens, wait several moments and then re-enter the command.
To remove options, including older options with 6-character keys:

set license delete option {probe | snmp}
Note: When an option license is deleted, the option will still function
until the next reboot.
Note: The "probe" and "snmp" options will be displayed with the show
option command, but Symmetricom does not offer license keys for
the "probe" option.
098-00028-003 Revision A – June, 2011
TimeProvider 5000 CLI Command Set
command, the default configuration will
TimeProvider 5000 User's Guide 141
Chapter 3
"set option"
set