Symmetricom TimeProvider 5000 User Manual page 171

show pps-tod
This command displays the pps-tod input ports (port1 and port 2) configuration and
status information.
Command Syntax:
To show pps-tod input ports configuration:

show pps-tod config
To show pps-tod input ports status:

show pps-tod status
Example1:
tp5000>show pps-tod config
Response1:
PPS-TOD Input Ports Configuration
-----------------------------------------------
|
|---------------------|---------|--------------|
| Port 1 |
|.........|...........|..........|.............|
| Port 2 |
------------------------------------------------
Example2:
tp5000>show pps-tod status
Response2:
PPS-TOD Input Ports Status
-------------------------------------------------------------------
| Status
|-------------------------------------------|----------------------|
| Port ststus
|....................|.......................|.....................|
| PPS ststus
|....................|.......................|.....................|
| PPS phase offset |
|....................|.......................|.....................|
| Clock source type|
|....................|.......................|.....................|
| Clock source status|
098-00028-003 Revision A – June, 2011
Port # | State
enable
disable
|
| normal
| normal
10
0x00
0x00
TimeProvider 5000 CLI Command Set
| Priority | Cable Delay |
| 3 | 100
| 4 |
Port 1 |
| disabled | error
|
|
|
|
TimeProvider 5000 User's Guide 171
Chapter 3
|
100 |
Port 2 |
|
n/a |
n/a |
n/a |
n/a |