User Level And Access; Managing The User Access List - Symmetricom TimeProvider 5000 User Manual

Chapter 4 Provisioning

Managing the User Access List

Note: SSH can be used to connect to the TP5000. The SSH firewall
is set to Allow by default.
3. Type your user name and press Enter. If you are not assigned as a user in the
system, contact the system administrator or see
4. Type your assigned password and press Enter. The system prompt appears.
Managing the User Access List
When you are logged in at the Admin level you can add, edit, or delete user names
in the user access list. The user list can contain up to 20 names and users can be
set to one of three different security levels described in
required to enter a user name and password to log in to the system. Users can
access or modify only the parameter settings allowed by their assigned security
level.
Caution: To avoid a possible service call, do not lose or misplace the
user name and password of the Admin-level user.
Table 4-1. User Level and Access
Security Level
User
Config
Admin
Use the procedures in this section to manage user access to the TimeProvider
5000.
234 TimeProvider 5000 User's Guide
Users can edit their password and show information, or access any
command at the User security level.
Users are allowed to change configuration and issue User-level
commands.
Users are allowed to modify the security database or download new
firmware and issue commands at any level.
Adding a User, on page 235.
Table 4-1. Users are
Description
098-00028-003 Revision A – June, 2011