Symmetricom TimeProvider 5000 User Manual page 180

Chapter 3
TimeProvider 5000 CLI Command Set
Note: : If the Alternate Master mode is set to Enable, the alternate
master flag will be set in the PTP messages. If the alternate master
flag is set, the TP5000 will not run the Best Master Clock (BMC)
algorithm and will stay in master mode.
Ranges:
addr-mode = Unicast, Multicast, Multicast-hybrid
mgmt-addr-mode = Unicast, Multicast
two-step = Enable or Disable
ttl = 1 to 255
alternative-master = Enable or Disable
PTP state = Enable or Disable
PTP dither = Enable or Disable
max-client = 1 to 500
announce-limit = -4 to 4
sync-limit = -7 to 7
delay-limit = -7 to 7
domain-value = 0 to 255
dscp-value = 0 to 63
dscp-state = Enable or Disable
priority-1 = 0 to 255
priority-2 = 0 to 255
PTP transpot = Ethernet or IPv4
Multicast announce-timeout = 2 to 10
Multicast client-timeout = 10 to 3600
Multicast announce-int = -4 to +4
Multicast sync-int = -7 to +7
Multicast delay-int = -7 to +7
Multicast VLAN ID = 0 to 4094
Unicast Dynamic Negotiation = Enable or Disable
Unicast Dynamic Lease Duration = 10 to 1000 seconds
Unicast Static State = Enable or Disable
Unicast Static IP Address = Valid IPv4 Address
Unicast Static Clock-ID = 64-bit value
Unicast Static VLAN = 0 to 4094
Unicast Static announce-int = -7 to 7
Unicast Static sync-int = -4 to 4
Unicast Static delay-int = -7 to 7
Defaults:
addr-mode = Unicast
mgmt-addr-mode = Unicast
two-step = Disable
ttl = 64
alternative-master = Disable
PTP state = Enable
PTP dither = Disable
max-client value = 500
announce-limit = -4
180 TimeProvider 5000 User's Guide
(
0.0625 to 16 seconds
(0.0078125 to 128 seconds)
(0.0078125 to 128 seconds)
(0.0625 to 16 seconds)
(
0.0078125 to 128 seconds
(
0.0078125 to 128 seconds
(
0.0625 to 16 seconds
(
0.0078125 to 128 seconds
( )
0.125 seconds
098-00028-003 Revision A – June, 2011
)
)
)
(
0.0078125 to
)
128 seconds
)
)