Symmetricom TimeProvider 5000 User Manual page 269

2048kHz Frame Type
To provision Port 1 as an input port with a frametype of 2048kHz, CRC disabled,
SSM disabled, an SSM-value of 3, a Priority value of 1, and to enable the port:
Note: SSM is supported in v1.2 release, however the v1.3 release
does not support SSM for reference selection.
SSM will be supported in v2.0 release.
1. Login at the Admin or Config-user level.
2. Type
set io port1 input
3. Type
set input frametype port1 freq2048khz
4. Type
set input crc port1 disable
5. Type
set input ssm port1 disable
6. Type
set input ssm-value port1 3
7. Type
set input priority port1 1
8. Type
set input state port1 enable
CCS Frame Type
To provision Port 2 as an input port with a frametype of CCS, with CRC enabled,
SSM enabled, SSM-bit of 8, Priority value of 2, and enable the port:
Note: SSM is supported in v1.2 release, however the v1.3 release
does not support SSM for reference selection.
SSM will be supported in v2.0 release.
1. Login at the Admin or Config-user level.
2. Type
set io port2 input
3. Type
set input frametype port2 ccs
4. Type
set input crc port2 enable
5. Type
set input ssm port2 enable
6. Type
set input ssm-bit port2 8
098-00028-003 Revision A – June, 2011
Provisioning the Programmable E1/T1 Inputs
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
Chapter 4 Provisioning
and press Enter.
TimeProvider 5000 User's Guide 269