Symmetricom TimeProvider 5000 User Manual page 131

show ip
This command displays the Host, Mask, and Gateway IP addresses for Ethernet
interfaces on the specified module. It also indicates if DHCP is enabled and if the
port is enabled.
Command Syntax:
To show the configuration of the Ethernet interfaces for the specified module

(some settings will only be implemented after restarting the IP interface):
show ip config {imc | ioc1 | exp[0-9]}
To show the current status of the Ethernet interfaces for the specified module:

show ip status {imc | ioc1 | exp[0-9]}
Defaults:
See Table B-9
See Table B-14
Example 1:
To display the configuration of the Ethernet interfaces for the IMC module 
tp5000> show ip config imc
Response 1:
MGMT PORT PARAMETERS
IP mode
IP state
Example 2:
To display the configuration of the Ethernet interfaces for the IOC1 module 
tp5000> show ip config ioc1
Response 2:
ETH1 PORT PARAMETERS
IP address:
IP mask
IP gateway:
IP state
ETH2 PORT PARAMETERS
098-00028-003 Revision A – June, 2011
for default IP address for the IMC module.
for default IP address for IOC1 and IOC2 modules.
: dhcp
: enable
192.168.1.11
: 255.255.255.0
0.0.0.0
: enable
Chapter 3
TimeProvider 5000 CLI Command Set
TimeProvider 5000 User's Guide 131