Table of Contents
Advertisement
Introduction
1.2
Board-Specific Information
The CP6016 is a CompactPCI single-board computer based on the Intel® Core™2 Duo
processor built on 45-nm process technology and specifically designed for use in highly
integrated platforms with solid mechanical interfacing for a wide range of industrial environment
applications.
Some of the CP6016's outstanding features are:
• Intel® Core™2 Duo processor, T9400 (SV), 2.53 GHz, 1066 MHz FSB, 6 MB L2 cache
• 479-pin µFCBGA package
• 64 kB L1 and 6 MB L2 cache on-die, running at CPU speed
• Intel® 5100 Memory Controller Hub chipset with Intel® 82801IR I/O Contr. Hub 9R (ICH9R)
• Up to 8 GB registered DDR2 SDRAM memory with ECC running at 667 MHz (PC2-5300)
on two SO-RDIMM sockets
• ATI ES1000 2D graphics controller with 64 MB of DDR2 memory via a 32-bit/33 MHz PCI
interface
• Analog display support for up to 1600 x 1200 pixels at 16-bit and 75 Hz
• 64-bit/66 MHz PCI or PCI-X CompactPCI interface (PICMG 2.0)
• PMC interface with rear I/O support and bezel cutout on the front panel as well as PCI
functionality, 64-bit/66 MHz PCI or 64-bit/133 MHz PCI-X interface
• XMC interface utilizing a x8 lane PCI Express interconnection
• Five Gigabit Ethernet interfaces:
• Three Gigabit Ethernet interfaces on front I/O
• Two Gigabit Ethernet interfaces on rear I/O (PICMG 2.16)
• Three Gigabit Ethernet (GbE) controllers:
• One Intel® 82574L controller connected to one GbE port on the front panel
• Two Intel® 82571EB Dual Gigabit Ethernet controllers connected to two GbE ports on
the front panel and routed to rear I/O
• Six Serial ATA interfaces with SATA RAID 0/1/5/10 support:
• Two onboard Serial ATA interfaces
• Four Serial ATA interfaces on the rear I/O
• Socket for one Serial ATA 2.5" hard disk drive (HDD) or solid state drive (SSD)
• Seven USB ports:
• Two USB 2.0 ports on the front panel
• One onboard USB 2.0 port for the USB 2.0 NAND Flash module
• Four USB 2.0 ports on the rear I/O
• TCG 1.2 compliant Trusted Platform Module (TPM)
• Two SPI Flash chips for redundant uEFI BIOS (2 x 4 MB)
• Watchdog timer
• Battery-backed real-time clock (RTC)
• Two COM ports (RS-232):
• One COM port either on the front panel or on the rear I/O
• One COM port on the rear I/O
• Hot swap capability: as system controller or as peripheral device
• Supports PICMG Packet Switching Backplane Specification 2.16
• IPMI compliant Baseboard Management Controller
• 4HP, 6U CompactPCI
• Passive heat sink solution for forced-airflow cooling
• Several rear I/O configurations
• Rear I/O on J3 and J5; optionally on J4 for PMC only
• AMI Aptio®, a uEFI-compliant platform firmware (AMIBIOS8 successor)
Page 1 - 4
CP6016
ID 1022-3074, Rev. 2.0
Advertisement
Table of Contents
