Table of Contents
Advertisement
Introduction
The board is offered with various Board Support Packages including Windows and Linux
operating systems. For further information concerning the operating systems available for the
CP6002, please contact Kontron.
1.2
Board-Specific Information
The CP6002 is a CompactPCI single-board computer based on the Intel® Core™ i7 processor
and specifically designed for use in highly integrated platforms with solid mechanical interfacing
for a wide range of industrial environment applications.
Some of the CP6002's outstanding features are:
• Support for the following processors:
• Intel® Core™ i7-610E (SV) processor with ECC, 2.53 GHz
• Intel® Core™ i7-620LE (LV) processor with ECC, 2.0 GHz
• Intel® QM57 Express chipset
• Up to 8 GB, dual-channel, DDR3 SDRAM memory with ECC running at 1066 MHz
• Integrated 3D high-performance graphics controller with three high-resolution graphics in-
terfaces (VGA/DP/HDMI/DVI)
• 64-bit/66 MHz PCI or PCI-X CompactPCI interface (PICMG 2.0)
• Two PMC slots with PCI functionality, 64-bit/66 MHz PCI or 64-bit/100 MHz PCI-X inter-
face; one PMC slot provides rear I/O support
• Two XMC slots utilizing a x8 lane PCI Express interconnection
• Four Intel® 82574L Gigabit Ethernet controllers for:
• Up to two Gigabit Ethernet interfaces on front I/O
• Two Gigabit Ethernet interfaces on rear I/O (PICMG 2.16)
• Six Serial ATA interfaces with SATA RAID 0/1/5/10 support:
• Two onboard Serial ATA interfaces
• Four Serial ATA interfaces on the rear I/O
• Socket for one Serial ATA 2.5" hard disk drive (HDD) or solid state drive (SSD)
• Socket for one Serial ATA Flash module (SSD)
• CompactFlash socket
• Six USB ports:
• Two USB 2.0 ports on the front panel
• Four USB 2.0 ports on the rear I/O
• Two COM ports:
• One RS-232 COM port either on the front panel or on the rear I/O
• One RS-422 COM port on the rear I/O
• TCG 1.2 compliant Trusted Platform Module (TPM), on request
• Two SPI Flash chips for redundant uEFI BIOS
• Watchdog timer
• Battery-backed real-time clock (RTC)
• Three onboard DIP switches for board configuration
• Hot swap capability: as system controller or as peripheral device
• Supports PICMG Packet Switching Backplane Specification 2.16
• IPMI compliant Baseboard Management Controller
• 4HP, 6U CompactPCI
• Passive heat sink solution for forced-airflow cooling
• Several rear I/O configurations
• Rear I/O on J3 and J5; optionally on J4 for PMC only
• Two GPIOs on J5 (on request)
• AMI Aptio®, a uEFI-compliant platform firmware
Page 1 - 4
CP6002
ID 1036-6431, Rev. 2.0
Advertisement
Table of Contents
