Board-Specific Information - Kontron CP6500-V User Manual

CP6500-V
1.2.2

Board-Specific Information

The CP6500-V is a CompactPCI Celeron based single-board computer specifically designed
for use in highly integrated platforms with solid mechanical interfacing for a wide range of
industrial environment applications.
Some of the CP6500-V's outstanding features are:
• Intel Celeron microprocessor
• 479-pin µFCBGA package
• Up to 256 kB L2 cache on-die, running at CPU speed
• 100 MHz or 133 MHz processor system bus
• 815-B0 chipset
• Up to 512 MB SDRAM memory
• Integrated 3D VGA controller
• Analog display support up to 1600 x 1200 pixels at 8-bit and 75 Hz
• PMC interface (32-bit/33 MHz PCI, 3.3 V and 5 V) with rear I/O support and bezel cutout
on front panel and PCI functionality
• Two Fast Ethernet interfaces on the front panel switchable to rear I/O (PICMG 2.16)
• Two EIDE Ultra ATA/100 interfaces
• Optional socket for 2.5" hard disk
• Onboard CompactFlash type II socket (True IDE)
• Four USB ports
• Two USB 2.0 ports on the front panel
• Two USB 2.0 ports on rear I/O
• 1 MB onboard FWH for BIOS
• Hardware monitor integrated in Windbond Super I/O W83627HF
• Floppy disk interface on rear I/O
• One 32-bit PCI-to-PCI bridge at 33 MHz
• Watchdog timer
• Real-time clock
• Two COM ports
• one switchable to front or rear I/O with RS232 or RS422
• one only for rear I/O with RS232/RS422/RS485
• POST code or general purpose LEDs (Front-I and Front-II)
• I/O extension connector (LPC)
• 4HP, 6U CompactPCI
• Passive heat sink solution for external airflow
• AMI BIOS
• Compatible with CompactPCI spec. Rev. 2.3 (32-bit/33 MHz)
• Hot swap capability: as system controller or as peripheral device
• Supports PICMG Packet Switching Backplane Specification 2.16
• Several rear I/O configurations
• Rear I/O on J3, J4,and J5
ID 28945, Rev. 01 © 2005 Kontron Modular Computers GmbH
Introduction
Page 1 - 5