Board-Specific Information - Kontron CP308 User Manual

Introduction
1.1.2

Board-Specific Information

The CP308 is a CompactPCI single-board computer based on the Intel® Core™2 Duo
processor built on 45-nm process technology and specifically designed for use in highly
integrated platforms with solid mechanical interfacing for a wide range of industrial environment
applications.
Some of the CP308's outstanding features are:
• Support for the following small form factor processors:
• Intel® Core™2 Duo processor SU9300 (ULV), 1.2 GHz, 800 MHz FSB, 3 MB L2 cache
• Intel® Core™2 Duo processor SL9400 (LV), 1.86 GHz, 1066 MHz FSB, 6 MB L2 cache
• Intel® Core™2 Duo processor SP9300 (SV), 2.26 GHz, 1066 MHz FSB, 6 MB L2 cache
• 956-ball Micro-FCBGA package
• 64 kB L1 and up to 6 MB L2 cache on-die, running at CPU speed
• Mobile Intel® GS45 Express Chipset with 82801IUX (ICH9M-SFF)
• Up to 8 GB DDR3 SDRAM memory without ECC running at 800/1066 MHz
• Integrated 3D high performance VGA controller
• Analog display support for up to QXGA (2048 x 1536 pixels) resolution
• Two Gigabit Ethernet interfaces with Wake-on-LAN support (Intel® 82574L), switchable
to rear I/O
• Four Serial ATA (SATA) interfaces:
• Two SATA interfaces for the standard SATA onboard connectors for installing Serial
ATA 2.5" Hard Disk Drives (HDD) or Solid State Drives (SSD)
• Two SATA interfaces switchable either to the high-speed I/O extension connector or
to rear I/O
• Eight USB ports:
• Two USB 2.0 on front I/O
• Two USB 2.0 on rear I/O
• Three USB 2.0 interfaces for the onboard high-speed I/O extension connector
• One onboard USB 2.0 port for the USB 2.0 NAND Flash module
• One USB 2.0 NAND Flash module either on the 4HP or on the 8HP version
• One PS/2 interface available on the high-speed I/O extension connector
• Compatible with CompactPCI Specification PICMG 2.0 Rev. 3.0 and usable in the system
controller slot as well as in a peripheral slot (the PCI interface is isolated in peripheral slot)
• TCG 1.2-compliant Integrated Trusted Platform Module (iTPM)
• Two SPI Flash chips for redundant uEFI BIOS
• System Management Controller (SMC) for system control and hardware monitoring
• Watchdog timer
• Real-time clock
• Two COM ports:
• One COM port either on the front panel or on the rear I/O
• One COM port on the rear I/O
• Peripheral extension connectors:
• High-speed I/O extension connector
• High-speed graphics extension connector
• SPI extension connector
• 4HP or 8HP, 3U CompactPCI
• Several rear I/O configurations
• Power-up sequencing and in-rush current optimized design
• Passive heat sink solution for forced airflow cooling
• AMI Aptio®, a uEFI-compliant platform firmware (AMIBIOS8 successor)
Page 1 - 4
CP308
ID 1027-4487, Rev. 3.0