Cisco UC 320W Administration Manual page 8

Installing the Unified Communications System
Getting to Know the Cisco UC 320W
Unified Communications UC 320W Administration Guide
1 POWER/SYS On - Normal operation. Slow flashing - Booting up. Fast
flashing - Upgrading firmware. Off - No power.
2 LAN On - Connected to a device. Flashing - Sending or receiving data.
Off- Not connected.
3 WAN On - Connected to WAN. Flashing - Sending or receiving data. Off-
Not connected.
4 PHONE (FXS) On - Service is available on the port, and the port is not in
use. Slow Flashing - Service is available and the attached phone is off
hook (in use). Off - The port is disabled.
5 LINE (FXO) On - PSTN line loop detected. Slow Flashing - FXO port is
off hook (i.e, the port is in use). Off - Not connected.
6 WLAN On - Wireless radio is on. Flashing - Sending or receiving data.
Off - Disabled.
7 VM On - Voice mail is enabled. Fast Flashing - System is full. Slow
flashing - Retrieving or recording voice mail. Off - Disabled.
8 USB For future use.
9 WPS On - WiFi Protected Setup succeeded. Slow flashing - Setup is in
progress. Fast flashing - Setup error. Off - Not in use.
Back Panel
1 2
1 LINE (FXO) Connect phone lines for traditional telephone service.
2 PHONE (FXS) Connect an analog phone or fax machine.
3 WAN Connect to the broadband network access device or to an uplink
port on an Ethernet switch that is connected to the Internet.
4 LAN Connect IP phones and other network devices.
5 LINE OUT Connect to an external speaker system.
6 LINE IN Connect to an external music source for music on hold service
(optional).
7 Power Connect to a power source. Use only the provided power
adapter.
3 4 5 6 7
1
8