Verifying Phone Startup; Upgrading The Phone Firmware - Cisco UC 320W Administration Manual

Small business unified communications

Table of Contents

Installing the UC 320W and Phones

Verifying Phone Startup

Unified Communications UC 320W Administration Guide

After receiving power and network connectivity, the phone executes a boot-up

sequence. During this sequence, phones with screens display the Cisco logo and

then "Initializing Network." All of the lights on the phone will flash.

After your phone is successfully connected to the network, it receives a basic

configuration. On all models except Cisco SPA 501G, the time, date, extension

number, and softkeys appear on the display screen. On Cisco SPA 501G, which

has no display screen, you should hear a dial tone when picking up the handset or

pressing the speakerphone button.

If the phone does not start, confirm your installation and connections. If these are

correct, try unplugging the phone and plugging it back in again.

Use the 320W Configuration Utility to upgrade the firmware for all components of

the Unified Communications system.

Table of Contents