Managing Ip Phones - Cisco UC 320W Administration Manual

Updates

Managing IP Phones

Managing IP Phones
TIP
Unified Communications UC 320W Administration Guide
- Question mark: The device previously was active, but its current state is
unknown.
- Exclamation point: The device cannot be configured due to capacity
limits. The UC 320W supports up to two SPA 8800 IP Telephony
Gateways.
To manually add a SPA 8800 Gateway:
Click Create SPA 8800. Enter the MAC address in the following format:
xxxx.xxxx.xxxx, where x is a number or letter in the MAC address. A device's MAC
address can be found on the hardware label on the bottom panel of the device. To
save the information, click Done. To clear the fields without adding a device, click
Cancel.
To remove a manually added SPA 8800 Gateway:
Click the Delete (X) button for the device. When the confirmation message
appears, click OK to delete the device, or click Cancel to keep the device.
Use the IP Phones page to review the automatically discovered phones and SPA
500S expansion modules, also known as "attendant consoles" or "side cars." You
also can manually add phones and side cars that you intend to install later.
Opening this page: From the navigation pane, choose Updates > IP Phones.
Displayed information:
• Each device is listed by its model number and MAC address.
• If you are working from a previously applied configuration, the assigned
user is listed. To manage phone assignments, see the Assign Phones page.
• Icons provide more information:
- Check mark: The device is currently available.
- Plus sign: The device was added manually.
- Question mark: The device previously was active, but its current state is
unknown.
4
57