Programs
Editing Programs
Editing Programs
You must have Administrator or Super User access to modify any part of a program, which includes
the Steps, Acceleration/Deceleration rates, and Rotor and Labware. You can edit a program only
when it is not running.
To edit a program:
1
Select
Program
Figure 5.11 Program Button
2
Select the program you want to edit and select the
that selection will be cleared. If the program is running, the
3
On the
button.
4
On the
), then select the
Temp
and return to the previous page.
5
On the
button, and modify each set of parameters. Then select
Deleting Programs
You can delete any program that is not currently running.
1
On the
Figure 5.12 Program Button
5-6
from the side menu on the
page, select the numbered step you want to edit, then select the
Edit Program
page, select each button you want to modify (
Edit Step
button and enter the new parameters. Select
Clear
page, you can select the
Edit Program
page, select
Home
Program
page.
Home
button. If the program is selected to run,
Edit
button and/or the
Accel Decel
Save
from the side menu.
button will be disabled.
Edit
Edit Step
,
, and
Set Speed
Set Time
to save the changes
OK
Rotor Labware
.
PN B08115AF
Set