Table of Contents
Advertisement
Functional Pages
Substitute Rotor Run Page
• Enter the sedimentation coefficients for up to three particles of interest by selecting the
Sedimentation Coefficient buttons, with the --s designations, at the bottom of the page.
• When you have entered the fields, select the
the graph above. The x-axis is the relative position (volume) of gradient in the tube. The y-axis
is the relative concentration (density) of the materials. You can move the slider below the graph
to see the effect of a shorter run time.
• The
Reset
• The
Back
• The
Transfer
a live run.
• The
Save
a later time.
NOTE
Saving or transferring the simulated run settings does not save the simulation inputs, only the
current simulated run settings (including the adjustments for a shorter elapsed time, if applicable).
Substitute Rotor Run Page
Figure 8.83 Substitute Rotor Run Page
To convert a set of run settings from one type of rotor and labware to another, select the
button on the
Rotor Run
Rotor Run
for more information.
8-80
button clears all the fields.
button returns to the
Simulations
button transfers the current simulated run settings to the instrument settings for
button saves the simulated run settings as a named run program, which can be run at
Simulations Page
button to display the simulated run in
Simulate
Page.
to display the
Substitute Rotor Run
Substitute
page. See
Substitute
PN B08115AF
Advertisement
Table of Contents
