68 Electrical installation
Connecting the control cables
Before you connect the control cables, make sure that all option modules are
installed.
Refer to
Default I/O connection diagram (ABB standard macro)
default I/O connections of the ABB standard macro. For other macros, refer to the
ACS380 Firmware manual (3AXD50000029275 [English]).
Connect the cables as shown in
WARNING! Obey the instructions in chapter
you ignore them, injury or death, or damage to the equipment can occur.
Before you start the work, stop the drive and do the steps in section
before electrical work
Remove the front cover.
Control cable connection procedure
on page 15.
on page
on page 73.
Safety instructions
on page 13. If
Precautions
69
for the