Required Tools; Unpacking The Delivery - ABB ACS380 Hardware Manual

Required tools

To install the drive mechanically, you need the following tools:
• A drill and suitable drill bits
• A screwdriver or wrench with a set of suitable bits (PH0–3, PZ0–3, T15–40, S4–7)
(For motor cable terminals, the recommended shaft length is 150 mm)
• A tape measure and spirit level
• Personal protective equipment

Unpacking the delivery

The figure shows the drive package with its contents. Make sure that all of the items
are present and that there are no signs of damage.
Package contents:
• Drive
• Options, if ordered with a plus code
• Installation accessories (cable clamps, cable ties, hardware, etc.)
• Mounting template (for R3 and R4 frames only)
• Quick installation and start-up guide
• Hardware and Firmware manuals, if ordered with a plus code
Mechanical installation 43