ABB ACS380 Hardware Manual page 67

cable lug, and connect it to the grounding terminal.
4. Connect the phase conductors of the motor cable to the T1/U, T2/V and T3/W
motor terminals.
5. If it is applicable, connect the brake resistor cable to the R- and UDC+ terminals.
Use a shielded cable and ground the shield under the grounding clamp.
6. Strip the input power cable.
7. If the input power cable has a shield, twist it into a bundle, put yellow-green
insulation tape on it, fit a cable lug, and connect it to the grounding terminal.
8. Connect the PE conductor of the input power cable to the grounding terminal.
9. If the combined cross-sectional area of the cable shield and PE conductor is not
sufficient, use an additional PE conductor.
10. Connect the phase conductors of the input power cable to the L1, L2 and L3 input
terminals.
11. Mechanically attach all of the cables on the outside of the drive.
Electrical installation 67