Electrical Installation; Contents Of This Chapter; Warnings; Required Tools - ABB ACS380 Hardware Manual

Electrical installation

Contents of this chapter

The chapter describes how to check the insulation of the installation and the
compatibility with IT (ungrounded) and corner-grounded TN systems. It shows how to
connect the power and control cables, install optional modules and connect a PC.

Warnings

WARNING! Obey the instructions in
ignore them, injury or death, or damage to the equipment can occur.
WARNING! Make sure that the drive is disconnected from the input power
during installation. Before you do work on the drive, wait for 5 minutes after you
disconnect the input power.

Required tools

To perform the electrical installation, you need the following tools:
• Wire stripper
• Screwdriver or wrench with a set of suitable bits
• Multimeter and voltage detector
• Personal protective equipment
Electrical installation 61
Safety instructions on page 13. If you
6