Ce Marking; Compliance With The European Low Voltage Directive; Compliance With The European Emc Directive; Compliance With The European Rohs Directive - ABB ACS380 Hardware Manual

EN 62061:2005 +
AC:2010 + A1:2013 +
A2:2015
EN 61800-3:2004 +
A1:2012
IEC 61800-3:2004 +
A1:2011
IEC/EN 61800-5-1:2007 Adjustable speed electrical power drive systems – Part 5-1: Safety
ANSI/UL 61800-5-
1:2015
CSA C22.2 No. 274-13

CE marking

A CE mark is attached to the drive to verify that the drive follows the provisions of the
European Low Voltage, EMC, RoHS and WEEE Directives.The CE marking also
verifies that the drive, in regard to its safety functions (such as Safe torque off),
conforms with the Machinery Directive as a safety component.


Compliance with the European Low Voltage Directive

The compliance with the European Low Voltage Directive has been verified according
to standard EN 61800-5-1:2007. Declaration is available on the Internet.


Compliance with the European EMC Directive

The EMC Directive defines the requirements for immunity and emissions of electrical
equipment used within the European Union. The EMC product standard (EN 61800-
3:2004 + A1:2012) covers requirements stated for drives. Refer to
EN 61800-3:2004 + A1:2012
Internet.


Compliance with the European RoHS Directive

The RoHS Directive defines the restriction of the use of certain hazardous
substances in electrical and electronic equipment. The declaration is available on the
Internet.


Compliance with the European WEEE Directive

The WEEE Directive defines the regulated disposal and recycling of electric and
electrical equipment.
Safety of machinery – Functional safety of safety-related electrical,
electronic and programmable electronic control systems
Adjustable speed electrical power drive systems. Part 3: EMC
requirements and specific test methods
requirements – Electrical, thermal and energy
UL Standard for adjustable speed electrical power drive systems –
Part 5-1: Safety requirements – Electrical, thermal and energy
Adjustable speed drives
on page 115. The declaration is available on the
Technical data 113
Compliance with