Start-Up; Configuration Parameters - ABB ACS380 Hardware Manual

174 BREL-01 relay output extension module

Start-up

To configure the operation of the relays added with the BREL module:
1. Power up the drive.
2. Set the parameter 15.01 Extension module type to 5 (BREL).
3. Use the control panel on the drive and set the parameters for relay outputs 2 to 5
in 15 I/O extension module. Refer to ACS380 Firmware manual
(3AXD50000029275 [English]) for parameter descriptions.

Configuration parameters

The configuration parameters of the BREL module are in group 15 I/O extension
module.
No. Name/Value
15 I/O extension module
15.01 Extension module
type
BREL
15.02 Detected extension
module
BREL
15.04 RO status
Bit 0 RO2
Bit 1 RO3
Bit 2 RO4
Bit 3 RO5
15.05 RO force selection
Bit 0 RO2
Bit 1 RO3
Bit 2 RO4
Bit 3 RO5
15.06 RO forced data
Bit 0 RO2
Bit 1 RO3
Bit 2 RO4
Bit 3 RO5
15.07 RO2 source
Description
Sets the connected side-mounted extension module.
Basenut relay extension module
I/O extension module detected on the drive.
Basenut relay extension module
Status of the relay outputs.
Relay 2 output status. 1 = open / 0 = closed
Relay 3 output status. 1 = open / 0 = closed
Relay 4 output status. 1 = open / 0 = closed
Relay 5 output status. 1 = open / 0 = closed
Selection of relay outputs for forcing.
Relay 2 output status. 1 = selected to force / 0 = normal
Relay 3 output status. 1 = selected to force / 0 = normal
Relay 4 output status. 1 = selected to force / 0 = normal
Relay 5 output status. 1 = selected to force / 0 = normal
Relay output forcing.
Relay 2 output status. 1 = open / 0 = closed
Relay 3 output status. 1 = open / 0 = closed
Relay 4 output status. 1 = open / 0 = closed
Relay 5 output status. 1 = open / 0 = closed
Relay output 2 source selection.
Relay output 2 is open.
Relay output 2 is closed
For complete parameter list, refer to ACS380 Firmware
manual (3AXD50000029275 [English])
Def/FbEq16/32
None
5
None
5
1=1
1=1
1=1
0
1
...