Connecting The Control Cables; Terminals - ABB ACS800-U1 Hardware Manual

70 Electrical installation

Connecting the control cables

Lead the cable through the control cable entry (1).
Connect the control cables as described below. Connect the conductors to the
appropriate detachable terminals of the RMIO board (refer to
board (RMIO)
on page 85). Tighten the screws to secure the connection.

Terminals


Frame sizes R2 to R4
The control cable connection terminals
are exposed when the control panel
mounting platform is turned aside by
pulling this knob. Be careful, do not
use excess force when pulling.
Terminal for optional Prevention of
unexpected start-up (+Q950) or
optional Safe torque off (+Q967)
function.
Connect the external AGPS or ASTO
board here. See page 75 or 81.
I/O cables: Ground the
control cable shields in the
360-
holes with screws. See
degree grounding
(page 72).
Motor control and I/O
Detachable connection terminals (pull up)
X39 for control panel cable
Option module 1
X41
1
Option module 2
DDCS
communication
option module 3:
RDCO
Place the warning
sticker here