Installation; Installation Procedure; Unit Installation - JCM GLOBAL RDM-100 Series Integration Manual

3 INSTALLATION

This section provides installation and operating
instructions for the RDM-100 Banknote Validator
unit. The information within this section contains
the following features:

• Installation Procedure

• RDM-100 Installation Dimensions
Installation Procedure
To prepare the RDM-100 to Cash Box mounting
platform, six (6) holes are required to attached the
Rail Brackets, four (4) holes to install the Cash Box
Transport Guide Frame and a 123x42mm rectangle
cutout for placing the Cash Box Transport Assem-
bly ( ).
Figure 5
Figure 5 Set Up Holes
6xM4 Tapping Hole
Cash Box
Ceiling
Figure 5 Set Up Holes
U I
NIT NSTALLATION
Perform the following steps to install the RDM-100
Unit:
1. Confirm that the Rail Brackets (Figure 6 a) were
installed on both sides of RDM-100 Unit.
Figure 6 Rail Brackets Confirmation
a
Figure 6 Rail Brackets Confirmation
P/N 960-000186R_Rev. A {EDP #253995}
RDM-100™ Series Retail Deposit Module
4xM4 Tapping Hole
(or 4xØ4.5 Hole)
Rectangle Hole
(123mm x 42mm)
NOTE: There are three (3) Installation
Holes on each Rail Bracket.
2. Position the RDM-100 Unit to align the Rail
Bracket Installation Holes on the Cash Box Ceil-
ing to the Rail Brackets Holes. Attach the Rail
Brackets to the Cash Box Ceiling with the six (6)
M4x8 (or greater) Screws with Washers (Figure 7
a to a ).
1 6
Figure 7 Rail Brackets Holes
a a
2
a
1
Figure 7 Rail Brackets Holes
3. Withdraw the RDM-100 Unit from the home
position on the Cash Box Ceiling.
Figure 8 Unit Withdrawal
Figure 8 Unit Withdrawal
© 2016, JAPAN CASH MACHINE CO., LTD.
7
a
a
a
6
3
5
4
Cash Box
Ceiling