Atdetach; Wanmanufacturer; Atreset; Atcall - Teldat -3Ge-USB User Manual

7 Monitoring the device via Telnet

7.1.2 atdetach

Forces Teldat-3Ge-USB deregistration in the HSDPA/HSUPA network.
This command has no associated parameters.

7.1.3 wanmanufacturer

Displays the name of the WWAN module manufacturer the device is equipped with on the console. Example of use:
Enter a command>wwanmanufacturer
SIERRA
Enter a command>

7.1.4 atreset

Forces the device's WWAN modem to restart.
This command has no associated parameters.

7.1.5 atcall

Forces the data connection with the HSDPA/HSUPA network.
This command has no associated parameters.

7.1.6 athungup

Forces data disconnection with the HSDPA/HSUPA network.
This command has no associated parameters.

7.1.7 atgsm

This command is not active in the Teldat-3Ge-USB as it doesn't support voice.

7.1.8 puk

The PIN code appears in the corporate router configuration: in the rcellular1 interfaces for Teldat mode, or in DHCP
configuration for generic mode. If the PIN code is entered erroneously three times the SIM module blocks. To un-
block, enter the PUK code (Personal Unblocking Key), which enters the unblocking code. A new PIN code is entered
through a second parameter.
Enter a command>puk help
Enter PUK value
Usage: puk pukvalue [newpinvalue]
If omitted, newpinvalue is taken from configuration
Enter a command>

7.1.9 atcommand

Allows any AT command (you want to send to the module) to be executed.
Enter a command>atcommand help
Send an AT command to WWAN module
Usage: atcommand command
command,
The command must be between quotes
Enter a command>
48
AT command
Teldat S.A.
Teldat-3Ge-USB User Manual