Page 2
This publication is subject to change. Teldat S.A. offers no warranty whatsoever for information contained in this manual. Teldat S.A. is not liable for any direct, indirect, collateral, consequential or any other damage connected to the deliv- ery, supply or use of this manual.
Furthermore, it is crucial to avoid any kind of contact between the device components and necklaces, bracelets, rings, ties etc. Teldat T200 Router Family...
LAN users and accommodating teleprocess networks and SNA support. The Teldat T200 router has a 4 or 8 port Ethernet LAN Switch and a Fast Ethernet port that behaves as WAN. You can configure a serial port in the 4-port model, which can be used in X.25, SDLC, Frame Relay scenarios or with an external backup device.
Turn the switch ON. 1.2.1 Power Source Connection The Teldat T200 does not require any special conditions regarding voltage stability or protection against power loss, as it is already protected. To avoid electric shocks, residual current circulation and any other unwanted effects that may disrupt communica-...
SWITCH: The Teldat T200 incorporates a 4 or 8 port Switch 10/100BaseT with automatic MDI/MDIX for LAN (local area net- work) connection. It also has a LED indicating connectivity. Please pay close attention to the labelling to avoid confusing the switch with other port types.
Page 9
Fig. 9: SERIAL connector 1.2.2.1 Connecting for configuration The Teldat T200 has a RJ45 female connector on the rear panel labeled CONF. , which provides access to the router’s local console. For configuration purposes, connect the CONF. port to an asynchronous terminal (or to a PC with terminal emulation).
GREEN: Interface available. Blinking: Maintenance frame being sent. Switch(es) LAN Ethernet: (T200G) OFF: Switch(es) not available. RED: Active Switch(es), there are no active devices connected. GREEN: Active Switch(es), there is at least one active device connected. Blinking: “heartbeat” . Switch(es) LAN Ethernet: Teldat T200 Router Family...
(where there is a default configuration file config.def). This block is normally found on the underside of the Teldat t200. It should not be handled by the user unless it is ne- cessary to re establish the default configurations.
Page 12
Press any key to get started At this point, return microswitch 5 to the OFF position (you don’t need to turn off the device). The next time you re- start the device, the saved configuration will run. Teldat T200 Router Family...
2.2 Software Upgrading The Teldat T200 can be updated to newer versions. Please contact your dealer for furthet details on new versions. There are several ways to update a Teldat router. For further information, please see the software upgrading manual.
Page 16
TYPE CGSM LENGTH x WIDTH x HEIGHT 315mm x 240mm x 43.2mm (+4mm for the legs) WEIGHT 2050gr (+200gr for the 19” rack wings) Environmental Specifications AMBIENT TEMPERATURE -5º to 65ºC RELATIVE HUMDITY 10% to 95% Teldat T200 Router Family...
Need help?
Do you have a question about the T200 and is the answer not in the manual?
Questions and answers