Transferring An Existing Machine Data Record Or A Traversing (Machining) Program - Siemens SIMATIC S5 Manual

Fundamentals of COM 266
6.5 Transferring an Existing Machine Data Record or a
Traversing (Machining) Program
Once you have generated machine data in the programmer or on floppy disk, you
can load it into the IP 266 with the "Transfer" function.
Press <F4> in the "FUNCTION SELECT" menu to select the "Transfer"
function.
This function allows you to transfer machine data or traversing (machining)
programs from a source to a destination device.
The "TRANSMIT" (TRANSFER) form is displayed on the programmer screen.
Note:
The "Transfer" function can be invoked only when the axis status is "stopped"
(i. e. "finished").
Exception:
When an operation is aborted with "Error in position control loop", the machine
data can be edited and forwarded to the IP with <F6> with mode 4, even when
the axis status is "traversing".
6-50
IP 266
EWA 4NEB 812 6057-02