Module Overview Diagram - Siemens SIMATIC S5 Manual

IP 266
Locations of the interfaces on the IP 266
The IP 266 communicates with the I/Os over three interfaces located on its
frontplate.
FAULT
ANALOG
OUT
E
N
C
P
O
G
D
E
R
6
POSITIONING CONT.
MODUL IP 266
6ES5 266-8MA11
1 2 3 4 5 6
Figure 2-2. Module Overview Diagram
Note:
Be sure not to confuse the interface for the incremental position encoder with
the programmer port. When you connect these I/Os, remember that the
programmer port is the rightmost of the two 15-pin D SUB connectors.
In addition to the two 15-pin D SUB interfaces, the digital inputs and outputs
must be connected to the module's terminal block.
EWA 4NEB 812 6057-02
Technical Description of the IP 266
Elements on the IP 266 front plate
Fault LED Red LED
Analog output 9-pin D SUB
Incremental 15-pin D SUB
position encoder
Programmer 15-pin D SUB
port
Screw terminal For securing the
module
CAUTION!
Possibility of
confusion
2-3