System Configuration - Siemens SIMATIC S5 Manual

Fundamentals of COM 266
To call this utility,
• enter DSKMAINT <1> if you are using an older version of PCP/M-
• or DISK <1> if you are using the newest version
Please refer to your programmer manual for a detailed description of this utility.
6.1.2

System Configuration

• First of all, you should learn how to install COM 266 on your hard disk.
Load the PCP/M86 operating system
Insert the COM 266 floppy into drive A
You must now copy the contents of the floppy to USER extent 0 on the hard
disk.
To do so, enter the following line:
PIP B:=A: S5 PDC 13X.CMD <1>
This command copies the COM 266 program to USER extent 0 on your
hard disk.
In order to make it possible to invoke COM 266 from any USER
Set these file attributes with:
SET B: S5 PDC 13X.CMD[RO SYS] <1>
The program is now installed.
When you start S5-DOS, COM 266 will now appear in the "PACKAGE SELECT"
menu.
• Preparations for using a programmer that is not equipped with a hard disk
unit:
First, you must generate an S5-DOS floppy. To do so, copy the following files
to a new or blank floppy that has been formatted for PCP/M86:
S5WX000H.CMD
S5WX100X.CMD
S5WX200X.CMD
S5WX201X.CMD
S5WX202X.CMD
S5.CMD
S5KXS02X.CMD
S5KDS01X.DAT
S5KDS02X.DAT
6-2
IP 266
EWA 4NEB 812 6057-02