Com 266 Test Mode - Siemens SIMATIC S5 Manual

IP 266
And what now?
Machine data must be available on the IP 266 before you can proceed to the
"TEST" form.
If no valid machine data is in the IP's RAM, you must forward this data to the
IP 266 from the programmer, disk or EEPROM.
Select the source device and the number of the data block containing the
machine data.
If your source is a disk, enter the drive and the name of the source file.
Select the IP 266 as destination.
Start the transfer with <F4>.
Press <F8> to return to "FUNCTION SELECT".
If you have not yet generated machine data, please do so. You will find details on
this procedure in Section 6.4.1.
If your machine data is on EEPROM, transfer it to the IP's RAM with <F2>.
6.6

COM 266 Test Mode

COM's Test Mode allows you to test the interplay between the IP 266 and the
mechanical elements of the drive in all modes.
C A U T I O N:
If your system has just been installed, please follow the steps below in order.
Prerequisites:
• The programmer must be interfaced to the IP 266.
• The programmer must be in "ON LINE" mode. You can change the
programmer mode by pressing <F2> in the "PRESETS" form.
Start the "Test" function by pressing <F3> in the "FUNCTION SELECT"
menu.
The "TEST" form is displayed.
EWA 4NEB 812 6057-02
Fundamentals of COM 266
6-55