Error Transferring The Data Record - Siemens SIMATIC ET 200eco PN M12-L Equipment Manual

Parameter data record
B.3 Error transferring the data record
B.3

Error transferring the data record

Error transferring the data record
The I/O device checks the values of the transferred data record. Only if the values were
transferred without errors does the I/O device apply the values from the data record.
The "WRREC" instruction for writing data records returns corresponding error codes in the
"STATUS" parameter when errors occur. For STEP 7 you will also find the parameter
description in the STEP 7 online help.
The Error codes table shows the following:
• The specific error codes of the I/O device
• The meaning of the error code
• A suggestion for correcting the error
• The data record at which the error may occur
Table B- 2 Error codes
Error code in STATUS parame-
ter (hexadecimal)
Byte 0 Byte 1 Byte 2 Byte 3
DF 80 B0
DF 80 B1
DF 80 B2
DF 80 B8
DF 80 E0
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
88
Meaning
xx Number of the data record un-
known.
xx Length of the data record incorrect.
xx I/O device cannot be accessed:
xx Incorrect parameter.
xx Wrong version or error in the header
information.
01 Reserved bit set
02 Invalid diagnostics enable bit set for
operating mode.
06 Invalid coding for substitute value
behavior.
07 Invalid coding for replacement filter
time.
11 Invalid output range set.
CM 8x IO-Link + DIQ 8x24VDC M12-L 8xM12 (6ES7148-6JJ00-0BB0) communications module
Solution
Enter a valid number for the data
record.
Enter a valid value for the data rec-
ord length.
Check the assigned values for the
parameters of the "WRREC" instruc-
tion.
Check the parameters of the I/O
device.
Correct the version, length and
number of parameter blocks.
Check the parameters of the I/O
device.
Check the parameters of the I/O
device.
Check the parameters of the I/O
device.
Check the parameters of the I/O
device.
Check the parameters of the I/O
device.
Equipment Manual, 12/2022, A5E51718265-AB
DS128
✓
✓
✓
✓
✓
✓
✓
✓
✓