Siemens SIMATIC S5 Manual page 219

Fundamentals of COM 266
Header:
• The header is as follows before you start the "Transfer" function by pressing
<F4> in the "TRANSMIT" form:
The word "TRANSMIT" is shown as the name of the screen form.
The name of the software package is the same as in all screen forms.
The DEVICE field is blank, as is the field "BLOCK: DB".
• While the "Transfer" function is executing, the name of the screen form is
supplemented by either "MACHINEDATA" or "MACHINING PROGRAM" in
field 2 of the header, depending on your entries in the data area of the
"TRANSMIT" form.
The "DEVICE" field now shows the source device and the "BLOCK" field the
number of the data block you want to transfer. Field 2 of the header indicates
whether machine
transferred.
Data area:
Before starting the transfer, you must enter
• the source and
• the destination.
These values are displayed when the transfer function has been started.
"Data Block" field:
MACHINEDATA or MACHINING PROGRAMS with <F7>. When the Transfer
function is started, your selection is displayed in the header as supplement to the
name of the screen form.
6-52
data or traversing (machining)
Before starting the
programs
Transfer function, select
EWA 4NEB 812 6057-02
IP 266
are being
either