Siemens SIMATIC S5 Manual page 213

Fundamentals of COM 266
Data area:
Field name Type
O The current physical unit is displayed in the first output field. This unit is
applied to all distances and speeds.
• "mm"
• "0.1 in"
In the course of a traversing (machining) program, the unit can be
changed as often as necessary via G70/G71.
Tool offset O The tool offset status is displayed in this field.
• "off"
• "negative"
• "positive"
The sign of a value is not displayed in this field.
Offset O This field shows the number of the last zero offset.
• "undef"
• "1 on"
• "2 on"
• "3 on"
• "4 on"
Dimensions O The numerical values of the target functions (X functions) can be inter-
preted as either absolute or incremental values.
G70 Absolute
G71 Incremental
Program O %2 SAMPLE PROGRAM
header
Stat. number I Enter the block number as a numerical value in this field. A block num-
(Block number) ber may comprise up to three digits. Block numbers need not be entered
in ascending order. The blocks are processed in the order in which they
are entered, without regard to the block number.
"Type" column: I = input field, O = output field
6-46
Description
can be selected via G70
can be selected via G71
can be selected via G40
can be selected via G44
can be selected via G43
can be selected via G53
can be selected via G54
can be selected via G55
can be selected via G56
can be selected via G57
IP 266
EWA 4NEB 812 6057-02