Siemens SIMATIC S5 Manual page 335

IP 266
Error Code
Recovery Procedures
F3C File missing
F3D Directory full
F3E Disk full
F3F Incorrect file
F40 Syntax or name not correct
F41 Not allowed
F42 Data block missing
F43 Overwrite data block?
F44 Data block missing
F45 Delete data block?
F46 Deleted!
F48 Illegal value!
F4C Cable not connected!
F50 Data block missing
F51 Cable not connected to PG
F52 Memory on PCB (module) too small
F53 Watchdog error PCB
This error is flagged over the programmer interface, i.e. in COM 266 and in
those situations in which it is not possible to communicate with the
positioning module. This error is flagged in the following instances:
- The cable is not connected or is improperly connected
- The positioning module has no power supply
F54 Transmission (transfer) error
EWA 4NEB 812 6057-02
Troubleshooting
Cross-
Reference
Section 6
10-9