Powering The Machine; Turning Direction Of Hand Wheel; Opening/ Closing Front Cover; Attaching/ Removing Presser Foot - Brother 3534DT Operation Manual

Powering the machine

Turning on the machine
1. Insert the three-pin plug into the socket on the
bottom right side of the machine. Insert the
power supply plug into a power outlet.
2. Turn the main power and light switch <A> to "I"
mark (to "O" mark to turn off).
<A>
Operation
When the foot controller is pressed lightly, the
machine runs at a low speed. As the foot controller
is pressed further, the machine will increase
speed. When the foot controller is released, the
machine stops.
NOTE (For U.S.A. only):
Foot controller: Model KD-1902
This foot controller can be used on the machine
with product code 884-B02 and 884-B03.
* The product code is shown on the machine rating
plate.

Turning direction of hand wheel

The hand wheel <A> turns in a counterclockwise
direction (direction of arrow). This is the same
direction as an ordinary home sewing machine.
The needles move to their highest positions by
turning the hand wheel so that the mark <B>
on the hand wheel is aligned to the line on the
machine.
<B>
<A>
6

Opening/ Closing front cover

It is necessary to open the front cover when
threading this machine. Slide it to the right 1 and
open 2, or close it and slide it to the left.
CAUTION
For your safety, make sure that the front cover is
closed when operating the machine.
Always turn off the machine before opening the
front cover.
2

Attaching/ Removing presser foot

1. Turn off the main power and light switch or
disconnect the electric supply plug.
2. Raise the presser foot lever. 1
3. Turn the hand wheel 2 so that the mark on
the hand wheel is aligned to the line on the
machine. (See CHAPTER1 "Turning direction
of hand wheel".)
4. Push the button on the presser foot holder and
the standard presser foot will be released. 3 4
5. Raise the presser foot farther by pushing the
presser foot lever upward. Then remove the
presser foot and store it in a safe location.
6. Again, raise the presser foot farther by pushing
the presser foot lever upward. Then place the
presser foot just under the presser foot holder
<A> so that the groove in the bottom of the
presser foot holder <B> is aligned and catches
the bar on the top of the foot <C>. Then lower
the presser foot lever to attatch the foot,
pushing the button on the presser foot.
4
1
2
1
2
3
1
<A>
<B>
4
<C>