Table of Contents
Advertisement
S
S
YSTEM
OFTWARE
Overview
S
S
YSTEM
OFTWARE
This chapter describes how to install system software from the system software media.
The imagePRESS Server ships with system software pre-installed on the HDDs (hard disk
drives). If you need to reinstall system software in the future, use the two System Software
DVDs included in the media pack.
N
:
You can change the default language of the imagePRESS Server at any time using the
OTE
Configure tool available through Command WorkStation and WebTools. Launch Configure,
specify the language you want to display on the imagePRESS Server from Server > General >
Choose Server Language, and then click Apply.
Keep in mind the following when installing system software:
•
—All jobs in all print queues and all jobs archived locally on the imagePRESS Server
Jobs
hard disk are deleted when you install system software. To save jobs, ask the network
administrator to archive them to removable media or a network location, so that the jobs
can be imported back into the imagePRESS Server queue after system software
installation. For more information, see Command WorkStation Help.
•
—The list of jobs in the Job Log and any jobs in the queues are deleted when you
Job Log
install system software. The network administrator can use Command WorkStation to
save a current list of jobs (not the actual jobs) from the Job Log.
•
—All fonts on the HDDs are deleted when you install system software. Resident
Fonts
fonts are reinstalled when you reinstall system software. Any customer-supplied fonts must
be reinstalled by the network administrator (see Command WorkStation Help).
To determine which additional fonts were downloaded to the imagePRESS Server, print
the Font List before you install the system software and again after you complete the
system software installation. Any fonts not listed after installation will need to be
reinstalled. For more information about managing fonts, see Command WorkStation
Help.
•
—The imagePRESS Server ships with user software pre-installed on the
User Software
HDDs. During system software reinstallation, you are prompted to reinstall user software
using System Software DVD 2.
•
—When upgrading the system software, make sure to print a
Configuration page
Configuration page before installing any software (for instructions, see
The Configuration page provides a record of the customer's current Setup configurations.
132
page
49).
Advertisement
Table of Contents
